Any good phaser settings? All the phasers in the Kemper feel a bit bright so when it sweeps it feels a bit unnatural, like the frequency range is too large which changes the tone too much.
Any ideas?
Any good phaser settings? All the phasers in the Kemper feel a bit bright so when it sweeps it feels a bit unnatural, like the frequency range is too large which changes the tone too much.
Any ideas?
I've messed around with the mix setting and that seems to help a lot.
From the Main Manual chapter Phaser:
You cannot find this parameter in any vintage phaser, because it would have been too expensive to realize in the analog domain. With “Peak Spread” you can control the spread and width of the phaser’s peaks and notches in the frequency domain over a wide range. At a narrow setting (more to the left), you can hear the peaks being focused to a narrow field. As the spread is widened, the phaser becomes increasingly de-coupled, until it dominates the whole sound spectrum.
Thanks for that info. I had read that and tried it but I think the mix was too high also.