I came down to my studio and switched on the Kemper and the only output signal I'm getting is from the direct out. No signal from mains, no signal from monitor. Is there a way to reset the unit or something???
dead profiler??
- stacey11
- Thread is marked as Resolved.
-
-
Is the Master Volume turned all the way down?
-
Or perhaps a loop not closed?
-
Master is not all the way down, and no outputs connected but for the mains to the power amp. The tuner is also frozen/garbles; bubble tuner not moving, strobe wildly spinning.
-
-
Maybe dumb; but have you double checked that your cable is in the Input and not Headphone Jack?
Edit: I see you’re getting full signal from the Direct Out, so that answers that question. I’d be looking in the Output menu to see if you accidentally altered the settings. Otherwise a reset seems in order.
-
A support it is, then.