Conflict between Remote and MIDI signal...?

    Hi everyone,


    I've just notice something : in the Performance mode, inside the square on the left, I used to see the MIDI Program and Bank numbers. But with the Remote plugged in, these informations disappear (and reappear when I remove the remote). Does that mean there's some kind of conflict between a MIDI signal sent to the Kemper and the Remote (I ask because I've just completely lost any MIDI communication between my KPA and my sound card... Remote plugged in or not) ?...

    No that's OK now.

    It turns out that... both my MIDI were dead at the same time ! So when I was switching one for the other, verifying that it wasn't a cable problem, I was switching a dead cable by a dead cable... X/

    Unbelievable...