I need a mono delay of 2857ms for a song. Is there no way that the mono delays can get a longer delay time than 2000ms?
Maximum delay time for mono delay
- Vinny Burns
- Thread is marked as Resolved.
-
-
You need a three second delay??
-
You need a three second delay??
Yes.
-
For dry signal you can use parallel path and two delays in series(100% wet).
-
........ for this section. Go to 4:40.
-
For dry signal you can use parallel path and two delays in series(100% wet).
How does this work with amp, cab and all my other effects in that rig? It’s a part of a performance and is only used for one part of the song.
-
Maybe you could use looper?
-
Maybe you could use looper?
How so? I posted a clip above for what I need it for. How will the parallel path or looper work for this?
-
Parallel path will not work for you in that case.
I'm only giving a suggestions.
You can always buy some delay fx and use it in fx loop after the stack.
There is also del+rev fx module trick with dly+rev balance parameter in rig menu. But I'm not sure it will work with two delays in series.
You can also make a feature request topic.
-
Parallel path will not work for you in that case.
I'm only giving a suggestions.
You can always buy some delay fx and use it in fx loop after the stack.
There is also del+rev fx module trick with dly+rev balance parameter in rig menu. But I'm not sure it will work with two delays in series.
You can also make a feature request topic.
Thank you for the suggestions.
-
There is also serial delay . Have you tried it? The problem is how to mix wet signal with only dry. I will try to figure it out when I will be near my KPA.
-
There is also serial delay . Have you tried it?
No, I haven’t tried that. Thank you. Will go and check it out. Great if I can get this happening. It’s the only sound from the whole set I have not been able to reproduce coming from Fractal land to the Kemper.
-
set both feedbacks to 0% and delay time to max and delay ratio will be second delay time.
-
OK . Serial delay will not do.
Here a solution for you:
Put Single Delay in DLY module and use this settings:
Delay Time 2000ms
Feedback 0%
All other mods to 0
Stereo to 0
Ducking 0
Mix in central position: 100%/100%
Put a Single Delay in REV module and use this settings:
Delay Time 857 ms
Feedback 0%
all mods to 0
Sereo to 0
Ducking 0
Mix 100% WET (all the way to the right)
Delay time is sum of the first and second delay times(max 4s)
Go to RIG settings and set DEL+REV Routing full to the right : +100%
(Tested and works for me)
Hth!
-
You are cracy- in the most possible positive meaning...