Sorry if this has already been asked but I couldn't fine the response on the forum.
I am using two Mission pedals with the KPA. First pedal is controlling the Wha and the second for the volume but I am unable to find the trick to parameter the pedal 2 so that it control the monitor out volume rather that the input volume. 
If you go to the Master menu (press Master) check the second case (monitor out link) on top
Thanks guitanet70 but I have this setup but it does not help 
hmm. are you using midi or intrumentcable (balanced)? are you saying it controls the input level?
edit: ok, the missionpedal is MIDI right?
the missionpedal is MIDI right?
...till is not connected to a midi controller, not. It's just a normal exp. pedal, you can connect it directly to the KPA
ok, you were talking about cc-numbers so I assumed midi...but you say input level? you can put the volpedal before or after the amp. if you put it after the amp it won't affect the input level to the amp..is this what you're trying to achieve? you can change this in the systemsmenue.pedalsettings (or something) turn one of the knobs to switch between prestomp, post stomp, pre amp, post amp etc.....
I will try this now 
sorry, it's in the rigs-menue... 
Yes found it finally second page of rig - volume pedal settings. Many thanks 
great
