Solved: powered KPA volume is lower on preffered profiles after update .... ?

    I just ran the most recent update today and now various often used profiles seem to be at a much lower volume. Where previously Master Volume fairly low (-25 to -35) would be plenty loud for my small room (powered Kemper, Matrix Elements cab), .Now it needs more Master Volume and even at 0.0 is not very loud on favorite profiles. Upping Gain helps but defeats the purpose of having Gain where I want it.


    Have I somehow inadvertently tweaked a setting somewhere that I haven't found to reset? I've looked around and don't seen anything obvious. Any suggestions on what might be happening and how to get around it?


    Thanks!

    thanks, Paul , I’ll check the settings (have to find that menu, don’t recall touching it before.).


    if no luck, I’ll try a restore. I’ve had it shut down so maybe a restart will help (unlikely).

    Clean Sense (& distortion) was at 0.0, as before I assume. Bumping it all the way didn't add a lot and got the Input light glowing red (overload). At volume -10dB now, it is less loud than -25-30 db was previously.


    Frustrating, a restore is a bit of a chore given my physical setup but that may be the next option (?).

    Eureka .... it was the nut behind the wheel.... Volume pedal on full = as it should be (duh). I'll post this here again in case others learn from my oversight.


    QUOTE:


    45-76b07feeaa3516eab48dfeaed3037a78a617d8e3.jpg
    DonPetersen
    Moderator

    also make sure you don't have a volume pedal connected and it's set to let through only a tiny bit of signal. (me -> guilty)


    X/