I picked up an Art SLA2 power amp to go between my Kemper Stage and a Marshall 1960a cabinet. (Art manual: https://artproaudio.com/framew…loads/2018/06/om_sla2.pdf)
The Art needs to see at least 8 ohms in bridge mode but I can't do that since the cab is 4 ohms mono or 16 ohms stereo. That leaves stereo mode on the Art which needs to see at least 4 ohms.
So this is what I've done.
I've taken two speakers cables and snipped off one side. The wire with the wording on it runs to the centre ring of the jack so I've placed tape on them and marked them negative on the other side at the bare wire.
I then connect the two cables to the back of the Art setting the switch to stereo mode.
The last step is putting the cab into stereo mode and connecting both speaker 1/4 plugs into the cab.
Is all this correct?
Greatly appreciate any help.
[Blocked Image: https://i.imgur.com/srxtpLI.jpg]
[Blocked Image: https://i.imgur.com/emRuFzj.jpg]
[Blocked Image: https://i.imgur.com/EDaE60E.jpg]
[Blocked Image: https://i.imgur.com/jkOyWYs.jpg][Blocked Image: https://i.imgur.com/kzDRlyz.jpg][Blocked Image: https://i.imgur.com/jWNLXFO.jpg?1]