Hello there
Does anybody know how i assign the wah stomp pedal to the pedals on the behringer fcb 1010?
Hello there
Does anybody know how i assign the wah stomp pedal to the pedals on the behringer fcb 1010?
Wah in the KPA must be in a stomp slot, switched ON. It must be set to pedal mode.
The FCB must send Midi CC 01.
Before using the FCB's pedals a calibration is recommended.
That's all.
Wah in the KPA must be in a stomp slot, switched ON. It must be set to pedal mode.
The FCB must send Midi CC 01.
Before using the FCB's pedals a calibration is recommended.
That's all.
Hello there..
How do i set the FCB to send a Midi CC 01 signal?
If you have an FCB, I highly recommend to upgrade it with the UnO chip for 16.- Euro.
Invest another 16.- Euro in the Editor software and you´re done.
UnO chip: http://www.ossandust.be/
Editor: http://www.lg-fcb.com/lgfcb_software.php
If you have an FCB, I highly recommend to upgrade it with the UnO chip for 16.- Euro.
Invest another 16.- Euro in the Editor software and you´re done.
UnO chip: http://www.ossandust.be/
Editor: http://www.lg-fcb.com/lgfcb_software.php
Hello thx for the reply.
I cant do it without the chip?
Best regards
Yes you can do it without the chip..
You lose a lot of the stompbox functionality though so for 16.- it's a no-brainer.
OTOH you should definitely use that editor which makes programming the FCB very easy.
Yes you can do it without the chip..
You lose a lot of the stompbox functionality though so for 16.- it's a no-brainer.
OTOH you should definitely use that editor which makes programming the FCB very easy.
But how do i do it without the chip?
Best regards
Well, it's in the manual, and I can tell you this is an absolute PITA to program without an editor.
thx everybody i got it working..
by the way its a great wah.....