I'm sure this has been discussed already, however, I did a search and could not find anything?
Anyway, what is the step by step, connection to connection method to re-amp? I'm assuming I use the Kemper direct out routing it to a DAW track. But, once recorded, how to I route the recorded direct track back into the Kemper?
I think this thread contains all the basics. If you have SPDIF connection on your audio interface it is a good advise to use these for reamping. This will make sure you have an optimal signal path without the need of a reamping device.
Best way to cable for reamping?
Display MoreI think this thread contains all the basics. If you have SPDIF connection on your audio interface it is a good advise to use these for reamping. This will make sure you have an optimal signal path without the need of a reamping device.
Best way to cable for reamping?
Actually, that made me more confused.
Just give it a try, it reads far more difficult than it is...
Just give it a try, it reads far more difficult than it is...
Will do...thanks.
You'll find infos on the wiKPA as well 
