Stereo Monitoring

kunerl · Feb 22nd 2013

Looking for a way to have a stereo Monitoring from the KPA - while using the Main outs Stereo for P.A.

I could use Monitor output (selected Master left) and Direct out (selected Master right) - then I could monitor with FRFR Monitors.
But when i want to have a Stereo Monitoring without cab sim I can only select Monitor out with Cab sim off. As far as I know it can´t be switched off at the Direct out?
Does somebody have a solution for Stereo Monitoring with cab sim off?
Would be very thankfull for any suggestions.

Gitarrenschlumpf · Feb 22nd 2013

Sorry but there ist no solution at this time.

musicman65 · Feb 23rd 2013

Even stereo FTFR monitoring via monitor and direct out is not a good solution today. There is still work that needs to be done.

guitarnet70 · Feb 23rd 2013

If you monitor stereo with FRFR take the 1/4 main outs.

kunerl · Feb 23rd 2013

Quote from guitarnet70

If you monitor stereo with FRFR take the 1/4 main outs.

o.k. good idea for FRFR, thanks a lot.
any other ideas for cab sim off?

guitarnet70 · Feb 23rd 2013

Quote from kunerl

any other ideas for cab sim off?

In stereo is only possible if you switch the cab off from the front panel and use the main outs, but then you'll need to mic the cabs for the FOH. Otherwise in mono from monitor out.

prickstein · Oct 30th 2013

Still nothing on the stereo guitar cab monitoring situation?

How about unlinking the XLR and Quarter Inch Jack Main Outs so that my signal remains the same to FOH and the Jacks can feed a stereo power amp while it's volume is adjusted by the KPA's master volume?

viabcroce · Oct 30th 2013

Well, the point here is not that you can't stereo-monitor the KPA, it's just that you can't have cabs off in the Monitor only.
OTOH, monitoring with a couple of guitar cabs while sending a stereo signal to FOH is a scenario I had personally not taken into consideration before

Share