Stereo spdif

knock88 · Jun 1st 2013

Hello

Is it possible to connect kpa via spdif to Audio interface and play in stereo.

I connect it like this and get no sound.

I find no Information in the wikipa. ..

Thanks

Trazan · Jun 1st 2013

Push the Output button and find the page with spdif. Then chose what you want to transmit through spdif.

viabcroce · Jun 3rd 2013

Hey Knock,

the wiKPA purposely avoids to report basic things that are covered in the (2) manuals available for the unit, unless they're seen in a particular way or are part of a larger discussion. so for your best knowledge of the KPA I'd advise you to read both!

knock88 · Jun 3rd 2013

Hi,

I realized that i only need one spdif cable for Stereo

It worked on cubase with the monitor button

But out of cubase on win 7 i dont get it.

I deaktivate the on board soundcard and play with the mix knobs off my Audio interface

Nothing

Quitty · Jun 4th 2013

As Trazan said, press the 'output' button on the KPA, browse around and set what you want transmitted over s/pdif.
Also, make sure you've connected the cable to the output and not the input by mistake.

knock88 · Jun 4th 2013

it worked on cubase but how does it work on win 7 ?

KoMa · Jun 4th 2013

You need an ASIO host in order to hear your signal via spdif. Like for example Cubase. You can't just switch on your computer and hear the spdif output through your speakers.

knock88 · Jun 4th 2013

ah,

good to know.

thanks

KoMa · Jun 4th 2013

You're welcome!

Share