While installing the new firmware 2.0 my KPA has shut down. Now he can not be switched on ! No lights and display is burning.
What can I do?
Help !! KPA can not be switched on
- Fender
- Closed
- Thread is marked as Resolved.
-
-
First disconnect from mains for a few minutes and try to boot again.
If this doesn't help you could boot from USB.
To do this you must put the kaos.bin in the root folder of the USB, not in the update folder.
Then switch on the KPA while pressing page < > -
No ! There is no light, nothing. It seems as if he gets no power.
I try to put the kaos.bin in the root folder. -
Hi Ingolf,
did not work.
The KPA does not boot up. -
So he gets no power at all?
Then disconnect from mains and wait approximately 20 minutes.
Then plug in again and retry. -
Could it be a faulty power supply?
Are known problems with the power supply? -
Could it be a faulty power supply?
Are known problems with the power supply?
No, and I don't believe it's got to do with a fault power supply because it happened during the update process.
Have you tried another power chord then? -
Everything back in order !
After two 2 hours he got back the power. -
Excellent! There were similar stories in earlier days of updating the KPA, hence the recommendation to unplug from mains.