Posts by Ingolf
-
-
... or anything in between dB's...
Thanks for the tip. -
-
Wow!
Great piece of music and some very good ideas in this video, too.
I love it. -
Well, it's in the manual, and I can tell you this is an absolute PITA to program without an editor.
-
Yes you can do it without the chip..
You lose a lot of the stompbox functionality though so for 16.- it's a no-brainer.
OTOH you should definitely use that editor which makes programming the FCB very easy. -
If you have an FCB, I highly recommend to upgrade it with the UnO chip for 16.- Euro.
Invest another 16.- Euro in the Editor software and you´re done.
UnO chip: http://www.ossandust.be/
Editor: http://www.lg-fcb.com/lgfcb_software.php -
I have 2 Atomic FR and get very good results.
I don't play Trash, though.
The tweeters in the Atomic FRs are a bit sensitive to 'too much gain'. They tend to squeal in certain settings, which makes it a bit more difficult to achieve feedback under certain condititons.
But they don't sound harsh. -
Wah in the KPA must be in a stomp slot, switched ON. It must be set to pedal mode.
The FCB must send Midi CC 01.
Before using the FCB's pedals a calibration is recommended.
That's all. -
A manufacturer of an amp doesn't automatically make a good engineer to microphone and capture that amp.
Let the manufacturers do their job and let the talented engineers like Andy do their thing. -
Very professionally dealt with by Kemper.
That's what the warranty is for.
And the procedure should be all the same even if I lived in a house beside the production facility. -
thanks .. I have the same problem and now you have solved it.
One more question, how to set up both Exp 1 for Wah and Exp 2 for volume then?I follow your way, its work for volume but no luck for wah .. As for Wah, when I switch to toe position, it actually there is no sound, but to heel , I can hear the wah... something i might be missing?
Make sure Exp.1 isn't Internally doing volume AND wah.
Exp. must send midi CC 1, exp. 2 must send 7. -
Reminds me of a certain mode....
-
that's right, it needs to be in the patch on the hd
You're sure?
I have to double check this but I don't believe this is true.
AFAIK the midi command assignment page in the HD lets you assign every switch incl. looper switch + tap switch + pedal switches to a midi cc, regardless of a pedal being existant in the signal chain.
An additional pedal like the ex-1 for example is also clearly not in the signal chain but still can be used to control volume, delay mix and the like.
Exceptions to this are the bank up/down switches which cannot be assigned. -
You should contact support then.
-
-
I'm on 1.51 without any problems.
-
I'd open a support ticket.
-
You find it at the bottom of the device and on the last page of the system menu.
-
Press and hold the AMP Button.
Then you can modify the deep editing parameters like defintion etc.