Posts by stevekHQ

Quote from sambrox

Ps it stands for Low Frequency Compensation. It only affects rigs that were profiled pre FW 2.5, if I remember correctly.

Cheers,
Sam

ok.......thanks.

Low Freq. Cut?

On or off under what conditions?

Quote from HMVMike

I'm using a Ethercon feedthrough on a blank rack plate so the RJ45 is permanently attached behind to the rear of the rack. Saves having to muck around plugging stuff in around the back of my rack too at each gig.

I was going to get a rear rack panel/interface made. That is good thinking mike. Problem solved.....

thanks! Mark IIC+ profile is up.

Instead of just the bare RJ45 connector for the Remote and amp, consider changing to an Ethercon for better durability.

Bought a brand new Power Rack. It had 2.5 on it. First thing I did was upgrade to 3.0xxxx. Been running fine and no glitches.

More coming this evening. Going to profile one of my original Mark IIC+ slaved through a Strategy 400. It will blow your socks off.....

<p>Just put several Triaxis profiles up, a Het Live rig and the JJ-100....I will refine as I learn a bit more.</p>

New here. Not sure why it took me so long. Less than 24 hours in. Expect lots of Mesa profiles with the Triaxis, IIC+, Quad++ and some other stuff.

Bye bye Fractal - Hello Kemper

Steve