Input bug in 2.1.1?

Hi all,

I have been using small little MIDI files that I send with MainStage to set the input on the KPA (enable/disable SPDIF). Last night, I was going to use only the digital input, so I locked it. After that, every time I changed patches in MainStage, the KPA had no input signal. Rebooting the KPA would fix it. After lots of fiddling, I finally found that if I didn't send the MIDI command to enable the digital input (in this case unnecessary) everything was OK. I did not try again with the input unlocked. Maybe later today.

Thanks!

Ah, I see. Can we get the MIDI docs updated, then? Thanks!

Quote from ckemper

The Midi Doc is documenting parameter numbers, but not the values. So there was no update 'necessary'.
In the upcoming firmware the parameter number for input source will change.
The value will change for Spdif In.
And the parameter will not be reset after powering up. Is that the reason you send this parameter over and over?

I send the "on " message for patches where I'm using the Roland VG-99 guitar models as input. When I use my guitar's regular pickups, I switch the digital input off.

This did reset for me when I did a power cycle. Is that because I had the input locked to SPDIF?

OK, I send 0, it sets to front input. Either 2 or 1 sets it to SPDIF. How do I set it to Alt input?

Actually, it's not consistent at all. If I have a cable in the front input, most of the time the MIDI message to turn on the digital input works, but sometimes it doesn't. Not cool if I have a tuning set up on the VG-99. Ugh.

Quote from ckemper

When Spdif is not connected, it will take the front input.

It's always connected.