Hello, I was wondering if anyone had experienced anything similar or had any insight into an issue I'm having?
This morning I updated my Kemper Powerhead with KPA_Operating_System_2.4.2_svn9817_Release from KPA_Operating_System_2.4.1_svn9785_Public_Beta.
Upon doing so I noticed one profile I use a lot, namely GRS 5150 II LD 15, sounds fine for around 4 seconds then it sounds as though the treble rolls off and sounds very muffled. Imagine someone suddenly stands in front of your cabinet with a very thick block of foam!
This happens at 4 times out 5 when I switch to this profile.
It happens with any rig I have set up using this amp profile, but say GRS 5150 II LD 10 or another profile created by the same user same amp doesn't have the issue, which will probably have been a profile made in the same session maybe only minutes apart.
I have rolled back to the Public Beta and the issue is gone, works fine. Upgraded again to 2.4.2 and the issue is back. I have played through a few rigs in my Kemper and this profile seems to be the only one suffering this issue?