Hi Guys,
I'm sorry but I really can't figure this out on my own.
My Problem is the following: I use a Strymon Timeline in my Mono FX Loop, so it's getting its signal through the Direct Output. What's happening is, that if I change from a Rig without the FX Loop activated to one with it activated, the Delay from what was played before is still hearable. I know that I have to somehow change the Direct Output to "off" on my Rigs, that don't use the FX Loop but I tried everything and It just won't save the settings.
The first time after saving the settings it works but the moment I switch back from the FX-Rig (the one with the Loop activated) every Rig has the Direct Output enabled again...
How do I need to save my output settings in order for this to work properly?
BTW this is all in Performence-Mode.
This I've tried so far:
Locking the Outputsection. Saving the Outputsettings in a Preset. Saving the Performence after editing the outputsection (I know this shouldn't help because I got it locked, but I just tried it).
Thanks in advance and sorry for my bad english.