I apologize in advance for my English - I write it in a translator.Hello, I needed to advise:I have Kemper Profiler Rack and I use it to do a custom made tool (electric guitar + electro-acoustic ukulele in one).In the guitar, I have the idea that one switch selects which tool is currently playing. There's one cable at the entrance to Kempra. However, ideally, I would need to divide the outputs so that I guitar and ukulele Rigas point out separately.With Line6 HELIX, Loop also be included at the end of the rigu-chain and the necessary patches for the ukulele to point to AUX-1 and AUX-2 as optional outputs (stereo output for ukulele).At Kempery, I have come to a single thing so far, and that is the appointment of ef. loops behind the "X" module and pull the signal in mono mode for that ukulele. This is a solution, but:1 / the loop (at least I think) can not be classified as reverb2 / it's mono and I would like stereo.I will be happy for any advice ... marianguitar http://www.mojagitara.com
http://mojagitara.com/category…paratura/kemper-profiler/
In Slovak:
Ahojte, potreboval by som poradiť:
Mám Kemper Profiler Rack a používam ho k takému na zákazku robenému nástroju (elektrická gitara + elektro-akustické ukulele v jednom).
V gitare to mám vymyslené tak, že jeden prepínač mi volí ktorý nástroj aktuálne hrá. Na vstup Kempra teda ide jeden kábel. Avšak ideálne by som potreboval nejako rozdeliť (nastaviť) výstupy tak aby som gitarové a ukulele Rigy nasmeroval von samostatne.
Pri Line6 HELIX sa dalo ef. loop zaradiť aj úplne na konci rigu - reťazca a potrebné patche pre ukulele nasmerovať na AUX-1 a AUX-2 ako voliteľné výstupy (stereo výstup pre ukulele).
Pri Kempery som zatiaľ došiel na jedinú vec a to je zaradenie ef. slučky za modul "X" a v mono mode vytiahnuť signál pre to ukulele. To je síce riešenie, ale:
1/ nedá sa ten loop (aspoň myslím) zaradiť až za reverb
2/ je to mono a chcel by som stereo.
Budem rád za každú radu... MARIANGUITAR