is anyone else experiencing problems with stomps after upgrade to 1.8.0 ?
changing browsing effects is very very noisey and some distortion stomps now unusable sounds like a cocked wah even if not playing....!
1.8.0 bug ?
- plek
- Closed
- Thread is marked as Resolved.
-
-
yes, I am plus none of the new pitch effects loaded on my system.
-
Jeddie: use the Type knob, not the Browse one.
Plek: can you elaborate which stomps are sounding bad?
-
Plek: can you elaborate which stomps are sounding bad?
hi sage, mainly every high distortion stomp but it is very noisy when changing effects or profiles (rigs), it was so bad I had to downgrade to 1.7.0
-
If i use the stomps and pick the pitch shifter im getting some horrible crackeling and noise.
Do i need to do a system reset if so how please
-
hi sage, mainly every high distortion stomp but it is very noisy when changing effects or profiles (rigs), it was so bad I had to downgrade to 1.7.0
Please log a ticket and send a fresh backup to support. Here is not the case.
-
hi sage, mainly every high distortion stomp but it is very noisy when changing effects or profiles (rigs), it was so bad I had to downgrade to 1.7.0
Did you get this solved or is it still in progress
-
Believe the noise is normal if your using a high gain profile , because when your browsing effects you hit distortion pedals plus the distorsion of the high gain amps=noise, this happened before tho and I think it's normal
-
What about the clicks I get with the pitch shifter and others are getting
-
Anyone having stomps not retaining their state? My clean profiles always have a compressor in the first slot, set to "on." Now when I switch to that rig, it defaults to "off." I turned it back on and saved/overwrote the profile, then switched to it again, it went back to "off." I did this a few times while toggling the FCB button for that stomp, to see if that would change anything, still same result. Anyone having the same or have suggestions? Thanks.
-
Blackbird, are you using the FCB with UNO in stompbox mode? If yes you also have to perset that particular stomp button to 'on' on the FCB so that the state of the FCB reflects the stomps state on the KPA. This should solve your issue!?
Cheers,
Markus -
Now the KPA responds to the CC sent by the footcontroller with the original PC.
Did you check if your FCB is sending the CC for stomp A while you change the PC? -
Thanks for the responses guys. I'm actually using the HD500 for patch changes. Jimmyno, I'm not quite sure I understand your suggestion, I'm going to open HD500edit tonight on my computer and take a look. Are you saying that now there is a CC for "on" and a CC for "off" for the stomps? Thanks again!
-
Did you get this solved or is it still in progress
all resolved now thank you all, downgraded OS and upgraded back to 1.8.0(new download) everything is as it should be no noise when browsing effects no dodgy distortion stomps... I put it down to bad download of OS
thanks again