I see no way to add/delete My Rigs contents. I also searched all the doc I have and could not find any instructions. Can someone from Kemper please help with this?
Posts by Zappledan
-
-
I've had issues with cables that have caused this type symptom. Try swapping them to see if the problem stays with the channel or the cable ...
-
I've had several issues that turned out to be cables ...
-
NIce job!
-
Great time for guitarist
+1000
-
+1 on using a mixer. I run my KPA outputs into a Mackie mixer, which allows me to blend any other sounds I want into the mix.
-
Press the leftmost selector button to choose Favourites.
Turn the Browse button on the right to view the list of current Favourites.
Turn the Browse button until a rig is highlighted that you do NOT want as a favorite.
Press the RIG button at the far left (next to SYSTEM).
Press the button labeled "Favourite *" above the details display. -
Also, I believe that there's a system option that determines whether saving a rig automatically puts it into the favorites.
-
Nice idea! I've often wondered how much expense is tied up in all those extra knobs that I never use ...
-
As mentioned previously, perhaps this is related to the Delay effect. I'm not currently using a MIDI controller, but I have noticed that when I switch to Tuner mode (with muting on) that the sound continues even after muting when there is delay being used.
-
These are 1/4" cables and short. No doubt at least one is defective, but it did get me thinking about how many cables are in use and whether they're impacting my sound. For anyone in the US needing cables, there is a sale at Lava - 25% off their cables and 15% off the cables they distribute for others, such as Sommers. Their price on Mogami 10' is really good ($26 less 15%), so I'm going to give those a try.
http://www.lavacable.com/index.php?id=82
Thanks to all for your input!
-
-
Excellent tip. Thanks!
-
-
-
OK, so this isn't a sexy subject, but one that I'm finding increasingly important, and also that I don't have much experience or knowledge about. After getting my backup KPA, connecting everything, then A/B-ing the two (both connected to a Mackie mixer, then to twin RCF ART310A's), I found that the new unit had much lower output levels. After checking every possible configuration value, and finding that they were identical, I swapped the output cables going to the Mackie. Voila, that was it. Huge difference. So now I'm looking at how many cables are involved in my setup, and wondering just what other impacts are being introduced? After a small amount of online research, I'm amazed at the price of "good" cables and wondering where the sweet spot is. What do you guys use for each of the connection points? For example:
Guitar into KPA
KPA to mixer
Mixer to RCF ART310A
Mic to mixerSame type cable for all of these, or are there subtle differences for best results? And how do you avoid spending a fortune?
-
-
Thanks, will give it a try
-
Thanks for sharing this. I no longer have any amps to A/B against, and this is useful info.
-
I am worried that some knobs are worn out quickly or break eventually.
I have the same fear, but I'm not sure that a librarian will help that as much as a foot controller and the perform mode.