First off, thanks for the help I've gotten so far in learning the KPA. Great forum! Also, I'm a bit confused regarding terminology- specifically rigs vs. profiles, so please excuse if I get those a bit mixed up. On to my problem:
I created a Marshall JTM30 profile, added some effects, and saved it. I then started from this, increased GAIN and some Amp settings, then saved that under a similar name with "Drive" at then end. So now there are two rigs. After booting the KPA, if I load the clean rig first, it sounds exactly as I remember saving it. However, if I go to the "Drive" rig, then immediately thereafter load the "Clean" rig, it becomes distorted and pretty nasty sounding. The only setting that appears to be different when doing this is GAIN, which is clicked up a few notches. Putting it back to zero does not eliminate the distortion, however. If I load some other rig in between the "Drive" and "Clean" rigs, then it works just fine. Anyone have a clue on this? Is there something I should rename so that these two don't conflict? I've shared both of these rigs already, if some kind soul would load them and try it on a different KPA. Many thanks!