monitor cab off must be checked (activated) when you use a nonlinear guitar cab connected to the speaker output.
Posts by Kemper Support #1
-
-
Alternativ kannst du auch einfach eine USB Tastatur an den Profiler anschließen und damit die Namen eintippen.
-
der -12dB switch senkt die Lautstärke für die XLR Ausgänge ab.
-
You need to set the interface to be the sync slave to avoid crackles when you connect the Profiler to the interface regardless if any converters from coaxial to optical are in the chain or not.
-
Der Rig Volume Regler regelt die Lautstärke des jeweiligen Rigs. Die Lautstärken der einzelnen Outputs werden im Output Menu geregelt.
Wenn man den Main Output vom Master Volume Regler trennt wird der Pegel der zum FOH geht davon nicht mehr beeinflusst. Der Rig Volume Regler beeinflusst aber weiterhin den Pegel, der an alle Ausgänge weitergeleitet wird. -
The sorting has no influence on the MIDI program change number that you have assigned to a specific rig.
-
Alphanumerical sorting is just one of several options. If you chose to sort by gain the order will be different.
The slots in perform mode have fixed assignments for program changes. -
to set the delay time in ms all you need to do is deactivate the "to tempo" option in the delay edit menu.
-
You can set the range of the pedal in the rig menu on the volume pedal settings page.
-
You can use the clean sens parameter in the input menu to control the level of the DI signal.
-
-
I've read it but can't find that update on the kemper site.
you wrote that you cannot find the 5.3.2 public beta on the Kemper website. In my reply i pointed out that you can use the latest version (5.4 PB) because it includes all fixes of previous versions.
-
the latest version always includes all changes from previous ones
-
Git Studio delivers a line level signal. You cannot change that level in the output menu by design.
If you get sonic artefacts on hard picks you are either clipping the input of your audio interface or the input of the Profiler. In the later case you should notice the input LED on the Profiler going into the red when you pick real hard. In that case i would suggest that you check the setup of your guitar pickups. Maybe they are too close to the strings. -
you can use pedals for volume,pitch, wah, morph and monitor volume. You can also use the pedal inputs to connect footswitches to switch between rigs, activate stomps etc.
-
While you can use several pedals to control morphing you cannot assign different morphing destinations to each pedal.
-
i cannot see any reason why you should not.
-
Switch the Profiler off. Then press and hold the RIG button and then set the chickenhead from the OFF position to the Browse position.
As soon as you see "Initialising current rig" in the display you can take the finger off the RIG button. -
The Profiler already offers user customisable scales for the harmony effect where you can set the interval for every note.
-
You can toggle the lock status for the module or section that is currently visible in the display. No need to keep any buttons pressed for that.
The setting of the locked module or section are global for all rigs in the mode you applied lock. Storing will have no influence on that.
As long as you use the RIG buttons to navigate through the 5 slots in a performance you only need to store the performance once before you select a different performance. Only if you use the Remote switches to navigate between the slots you must store every time before you change to the next slot.