Hello Friends!
First post from me.
When powering up the Kemper and switch into "performance"-mode some parameters loose it's settings.
When booted up and switching to "browser" mode all parameters looks intact but if you then switch into "performance" mode following happens:
1. The Clean/distortion sense becomes unlocked
2. The "Lock Vol. Pedal" (Rig p.3/3) becomes unchecked
3. Sometimes the "Range" parameter for Vol.pedal (Rig p.3/3) is reset to default -5.0 (my stored setting -4.9)
4. Sometimes Noisegate is set back to the Rigs default value
I've tried to Lock those parameters and store the Performance over and over and it stays as I set and store them as long as the KPA is on power.
After setting the above parameters, there is no problem to switch between Tuner/browser/performance everything stays but it's only when powered of and back on this happens.
Now I know which parameters to look for at start up, but it's a hassle to check every time.
I feel confident the Kemper Team will look into this (if it's a problem) maybe it's intended to work this way.
/ cheers F