Hi there!
just got an fcb1010 and upgraded with an standard UNO chip (1.0.3).
I never worked with midi, but thought some trial and error will bring me what I need..... thought...
initialised the uno firmware and then connected (via my Native Intsruments komplete audio 6) with Ripwerx (2.1).
Choose stomp box mode and programmed some stompboxslots. than transmitted the data to the fcb.
Connected it with 2 cables to the kemper. changing rigs with switch 1-5 worked. en-/disabling stomps worked as well (but on the fcb the light in the switch is ON when the stomp ass OFF and the other way round..)
then reconnected with ripwerx to do some other changes.
BUT
since then in stompboxmode nothing works. some leds (gain, presence) flash up when i push a switch but nothing changes. cant en/disable stomps and cant change rigs anymore. reinitialised the fcb, in normal mode everything ok, stompboxmode same problem even without any programming with ripwerx.
Any thoughts what may be wrong?
Other topic:
May someone send me his .syx file so that i can import, try, watch and maybe understand ripwerx a bit better?
Thanks