I have a question about the effect loop. When I plug my pedals into it they seem to work as pre loop and not post loop. My delay and chorus pedals gets all distorted when using the hi gain amps and it's like effect is on top of my signal not behind it as the way it is with other effect loops. Is there a problem with my amp or thats just the way KPA effects works? I hope not.
Effects Loop
- RPrad
- Closed
- Thread is marked as Resolved.
-
I am using "Effect Loop Mono" in X Slot and it works as expected.
Check if you put the Loop in more than one slot too. -
I am using "Effect Loop Mono" in X Slot and it works as expected.
Check if you put the Loop in more than one slot too.I am using "Effect Loop Mono" in X Slot and it works as expected.
Check if you put the Loop in more than one slot too.When I set the effects loop to any of the settings (mono or stereo) and try to use X setting I get no sound at all. Whats up? It does work if I use it in the stomp section but it sounds like crap.
-
Works fine in X on mine. Level and mix values set ok? Correct Send and Return jacks?
-
It is important that you have only one FX Loop in your rig and that need to be on X!
Because if you have a Fx Loop in A-D and in X, Kemper take always only the first one!Then check that X is ON and push LOCK. So it will be ON in all your rigs.
