Hi guys!
I have searched the forums as well as the Internet but have not found anything about this.
Got my KPA a week ago. It was a slightly used one but I bought it from a local store with warranty.
When starting it up the first time I did not have to enter my name and time so it was obviously not reset.
I found a soft key that said "Factory Rigs" so I ran that and as a result I got a total of 1349 rigs in the Kemper.
Next I installed to Rig Manager but only 1000 rigs where transferred.
I read in an article that only 1000 rigs could be stored in the Kemper so I thought I need to reduce the number of rigs.
Also I got the message on start-up of the Kemper that I could not add any more rigs since the rig memory was full.
I took a backup that resulted in 1298 rigs when mounting the backup in Rig Manager. The message from Rig Manager
was that some of the rigs where duplicates.
After the backup I found a soft key on the Kemper that said delete all rigs except Favourites. I pressed it and the Kemper
started deleting. And here is where the problem started. The Kemper froze. Nothing happened. It was on for two hour
but with no progress I decided to turn it off.
After that it did not want to start. I unplugged the power for 15 minutes and after that it started again.
BUT the funny thing is, now it powers on when I turn the chickenhead switch to Tuner. Before it froze it powered on when
the chickenhead was turned to Browse.
Is this a problem?
Eveeything else seems fine. I upgraded the software from 2.3.1. to 2.3.2. and only 349 rigs appeared. I used the Rig Manager to
remove them all but one and then used my backup to restore only 50+ of my favourites.
Everything seems to work. Syncing work with Rig Manager etc but the Kemper now always powers on when the chickenhead
is turned from OFF to Tuner instead of from Tuner to Browse.
Is that ok?
Regards
Georg