Lost delayed sound from my Rigs after upgrading to 2.3.3 *solved*

    Hi,


    I made a couple of rigs in the past where I can turn the delay on and off using one of the buttons of the FCB 1010 (UNO4Kemper). I recently upgraded from 2.2.1 to 2.3.3 and now I don't get any delayed sound from the delay. I can still turn the Delay section on and off with the FCB 1010, but the sound just stays the same, no difference if delay is on or off (and it was a Gilmour type of delay, nothing subtle). Didn't change anything in the rigs after upgrading. I am using a tap delay, could this be an issue with that beat scanner i read about? From looking at the delay settings i think i should hear something from it...


    Thanks for yor help.

    Edited once, last by Firebird ().

    Also have a look at the ducking parameter. E.g. there's a difference between -0.0 and <0.0>! If it's set to <0.0> you should hear the delay. Good luck!

    I could have farted and it would have sounded good! (Brian Johnson)

    Completely forgot to write here that i found the problem...


    After the update the monitor out was set to MOD. I set i back to main out and everything is fine.


    I'm pretty sure i didn't change the setting thou...