I was interested in acquiring one of these pickups for a new guitar I had in mind. But I don't want to drill any holes or anything.
Wondering whether it's possible to install it without routing. I don't need the controls on top and I don't mind leaving the cover off my electronics cavity. Alternatively, I wouldn't mind mounting the PCB board to the electronics cavity cover if possible, perhaps cutting short the switches so they don't get in the way.
I was thinking since the trim controls are set and forget, I could position the PCB upside down so that the switches for on/off and harmonics are facing inside the cavity, rather than outside.
Anyone done something like this or have some advice or warnings on this kind of installation?