Yes. Take a look at the output setup. There are some 4 band EQs for Main and Monitor Out.
... and you can save your settings as well, should you go to that venue again 
... and you can save your settings as well, should you go to that venue again
can you walk me through how to do that? I just got a kemper and knew about the output EQ and did some tweaking for our rehersal spot (to compensate for lots of carpet and wall sound deadening) but didn't know I could save that setting. i assume you can name it also? If you have couple stored settings, how would you go about selecting between them? My gig location is no carpet and all hard surfaces, so would be great to set up and recall separate EQ for that. Thanks in advance for any help!
I figured it out. Hit store and it asked either output or rig, clicked output and had the opportunity to name it. Then I went back into output, set everything back to <0> hit store then output, renamed to "flat" and stored. What took me a while was to figure out how to select between the two after I created them. I was hitting lots of buttons, then I thought to rotate the Browse knob and there I saw my two choices. Now to select all I have to do is hit the output button and then rotate the Browse knob. The current setting is the one highlighted, rotate the knob to the desired setting and since I have it set up to autoload, it switches right away to the new setting. Then hit the exit button and I'm done.
Correct
BTW, there's actually nothing to figure out: just read the manual 
