Pitch effect position

I have a rig that I have saved that uses the pedal pitch.

normally my pedals on my 1010 (with Uno4kemper) are all the way forward, which should result in no pitch change.

I have saved the rig with the effect on, but when I switch to it, the pitch pedal is activated as if the pedal was all the way down. If I move the pedal all the way back, then all the way back forward, it clears it out and works normally until I switch away and come back.

I have tried re-saving the rig with the pedal all the way up and it makes no difference. I always have to clear the pedal. Very annoying!

it is controlled by pedal touch.

The Pedal is set so the pitch will go DOWN as the pedal goes BACK.

if I switch to that rig with the pedal forward the pitch is down. If I then use the pedal to go back, then forward again, it's correct until I change the rig and then come back.

Every time the rig loads, the pedal pitch effect goes to it's lowest set point despite the pedal position.

Yeah, Looks like a bug.

Video

I recorded this with my iphone, while playing an untuned guitar with one hand

I'm using WAH to PITCH

While that makes sense if I want to pitch up, what if I want to pitch down? (Which IS what I want to do.

This seems pretty silly and unless you are "on the inside" I would guess this wasn't the intention.

I want to use it exactly the way you describe they have stopped me from using it, or the opposite way the have done it now.