I have been using my Kemper for a while and have always been underwhelmed with it through my interface, I obviously thought it was the interface/Daw's problem.
I did a test today in which I plugged my headphones into the various outputs to see if there was any sound difference, the headphone and the monitor outs sounded great but the moment I went to the main outs it sounded like I had rolled down my tone knob, any suggestions.
I have checked all the obvious, EQ, Space, ect ect everything is set completely flat. I even did a reset to check and make sure.
This has been an issue the whole time owning the device so I'm pretty sure it isn't a firmware thing.
Any advice would be very helpful