Problem selecting other cabs??

I've just had a sort out with my Kemper and installed 3.0.1 on it.

I also deleted all my profiles and started re installing only the ones I want.

I've selected a profile and went to change the cab to a cab from a profile I have installed but there are no cabs in my "from rigs" section.

It was the Beta. I went back to the previous update and now it's fine

Should I be able to cross any profile head unit with any profile cab?

I have over 100 profiles but only 60 cabs.

When I flick through the cabs, should every cab from every profile appear?

Thanks for your reply.

When I browse from rigs there isn't the full amount of cabs.

I've searched pre set and there are a few in there which I must have saved by accident at some point.

When I search from rigs there's nowhere near as many cabs to choose from as there are actual profiles.

Any ideas what this could be?

I've just gone and turned my Kemper on again and all the cabs are there this time!

Must have updated on start up.

Thanks for your help guys.

Do you press tag to save a cab to presets? Can I delete my cabs in presets without fully deleting the cab and start saving new ones?