FCB1010 problems

    Hi
    I don't know much about midi and stuff, but my Behringer FCB 1010 used to work perfectly with my Kemper. (I installed the UNO chip). Now all of a sudden it acts irraticly. Some axamples. The feedback from the Kemper to the pedal doesn't seem to work any more. Bank number, tuner effect on off. Control lights only work on the selection of the Rigs 1-5). Switching effects on and off doresn't seem to work properly.
    Can someone plzz help me out here? (maybe a step by step setup guide?)


    Thanks a lot.
    Steven

    Edited 2 times, last by Steven_nl ().

    Have you checked, that the FCB is recognized by the KPA? (this should be on the MIDI page in SYSTEM). The FCB normally sends an undocumented SysEx string to the KPA as kind of keep-alive signal.

    Usually the kemper would send a message whn the fcb is connected. Now it does not. I did a selftest with the fcb. Strange results. I guess it is dead. Have to get the kemper controller i guess. Lot of money.