Kemper stop with software error - see picture

Just wait for the support to respond your ticket. They may require you to send them backup file of your KPA.

Quote from skoczy

Just wait for the support to respond your ticket. They may require you to send them backup file of your KPA.

Good advice, any messages like that always require you to contact support I would say

Quote from Raoul23

Good advice, any messages like that always require you to contact support I would say

You would say?

Kemper's LCD says it all

[Blocked Image: http://s28.postimg.org/u4c9u6e19/kemper2.png]

Quote from skoczy

You would say?

Kemper's LCD says it all

[Blocked Image: http://s28.postimg.org/u4c9u6e19/kemper2.png]

Yes but there are always some people who might think they can fix it themselves

Did you disconnect Remote and try to reboot again ?

Corrupted RIG file i think. send backup to the support.

Is this occur when you try to switch to specific RIG?

Quote from mici01

Today (Sunday !!) the answer from Kemper Support
... "ich kann jetzt nur vermuten, daß da noch ein Abgleich mit Rig Manager bezüglich Änderungen in den Performances anhängig war. Ich würde ihnen empfehlen 3.2.0 einzuspielen. Die Performances werden ab da in einer neuen Datenstruktur gehalten, deshalb sind sie auch nicht rückwärtskompatibel. Sprich: Änderungen, die sie in einer Performance in 3.2 machen, würden beim Downgrade nach 3.1 verloren gehen. Aber in der 3.2 wurden einige Fehler gelöst.Ansonsten müssen sie keinen Reset machen, wenn das System jetzt fehlerfrei arbeitet.
"
Many thanks Kemper

I don't understand a word from it - but happy that it works for you:D