Hello everyone
I am a new Powerrack owner since three days, and my quest for tone has finally ended in the exact moment I plugged my guitar in the Kemper. Since then I keep waiting the whole day until I can go back to rehearsal room after work. It took me 20 years of buying expensive gear, which will now either be sold or stay there to catch dust in a corner, I found finally my holy grail and could not be happier!
I am now spending my time working through all the functions and gimmicks, reading Kemper Wiki, the manuals, this forum and watching tutorials, which is a lot of fun, so thank to everyone contributing to making this journey a lot more easier for a dummy like me.
Only my girlfriend thinks I have become crazy, as I even spend the last minutes before shutting the light in bed with watching tutorials and walkthroughs on my mobile, hahaha…
Anyway, there is the following question which I couldn’t get answered, and I think some of you will be for sure able to help me out on this:
When in Performance Mode, I try to make song changes and slot changes with my Behringer FCB1010, which is not provided with any chip. So, Song 1 says in Slot 1 “Midi Prg # 1” and “Midi Bank 1”, which is fine. In Slot 2 I have the same (which is not consistent imho) “Midi Prg # 1” and “Midi Bank 1”. In slot 3 it says “Midi Prg # 3” and “Midi Bank 1”, which make sense to me.
Is there a way to amend these settings? I would need Song 1 slot 2 to say “Midi Prg # 2” and “Midi Bank 1”, instead of “Midi Prg # 1” and “Midi Bank 1”, because otherwise Slot 2, which should be enabled with footswitch Nr. 2 on the FCB1010 remains unused…
Thanks for helping!!