I'm sure there are other threads for this, but I couldn't find any. I have a mission expression pedal and I want to connect it to my remote without running a cable back to my rack. Is this possible?
Thank You
I'm sure there are other threads for this, but I couldn't find any. I have a mission expression pedal and I want to connect it to my remote without running a cable back to my rack. Is this possible?
Thank You
Yes it is. Connect a TRS cable from the Mission to the Remote, then configure it in the profiler.
Do I need to run connect a TR cable to the remote as well?
I do this all the time ..Stereo jack cable into remote and thats it
Do I need to run connect a TR cable to the remote as well?
No.
Very cool. I can't wait to try it. Thank you
jhguitar,3
James from Mission said:
'Always use a TRS when hooking up the pedal (to Mission Pedal Out1, the other end of the cable goes to the KPA Pedal1 ~ which controls the pedal)
Mission Pedal Out 2, uses a TS cable that controls the toe switch on the EP-1. Connect the other end of the cable to KPA PEDAL 2.'
I'm a new guy trying to learn, also. My first post on this forum
My issue is that I do not want to run cables from the Kemper. I would like to connect the pedal directly to the footswitch to keep things simple and keep the stage clean.
My issue is that I do not want to run cables from the Kemper. I would like to connect the pedal directly to the footswitch to keep things simple and keep the stage clean.
Not a problem, connect your pedal to any one of the four pedal jacks on the remote and configure it in system settings the same as if it was connected to the KPA itself in pedal jack 1 or 2. HTH clear it up.
Not a problem, connect your pedal to any one of the four pedal jacks on the remote and configure it in system settings the same as if it was connected to the KPA itself in pedal jack 1 or 2. HTH clear it up.
True, but in this case the TS switch of the Mission will not be functional.
Personally I'd rather configure my Wah with one of the bypass@ parameters anyway.
Hello,
I connected my Mission to "Pedal 5" with TRS cable to function as a Wah pedal. However, when I'm reaching to the toe positions, suddenly the gain is decrease for a moment (I notice that it's not happening when I'm tweaking with the "Mix" parameter on the Wah configuration) - but still, Wh(a)y it's happening ?
Sorry to revive an old thread, but before I buy cables I wanna make sure.
Do both ends of the cable need to be TRS, or is one end TRS and the other end TS?
Thanks
Sorry to revive an old thread, but before I buy cables I wanna make sure.
Do both ends of the cable need to be TRS, or is one end TRS and the other end TS?
Thanks
Both ends should be the same.
You need TRS for pedal position signal and TS for switch signal. Although you could use TRS for both without problem.
P.