HELP! MY KEMPER IS LOCKED!!

Babau · Dec 7th 2015

Hi, sorry for my bad, bad english. This is my problem: while i was uploading the last firmware, 3.2.1, at the screen "updating panel firmware" my Kemper stopped; he loads a little portion of the "loading bar", but he arrives at 1\10 and then re-start again and again. Now he's locked in that screen. I've tried, after 1 Hour, to get off and on the unity, but nothing; it's completely locked. I don't know the reasons and i don't know can i do; anybody knows? If yes, please give me a feedback...i have many work to do with Kemper in the next days...

Thanks a lot.

Christian

Dragonsf · Dec 7th 2015

Have you tried the emergency procedure?http://www.wikpa.org/Emergency…filer_to_factory_defaults

Babau · Dec 7th 2015

No, now i will try. Thanks, mate!

Babau · Dec 7th 2015

No, it doesn't work...ever the same screen.

DamianGreda · Dec 7th 2015

Put the kaos.bin on root of your usb stick. Put stick into kpa . Hold both page buttons <> and turn kpa on to browse mode while holding the buttons.

Raoul23 · Dec 7th 2015

Quote from DamianGreda

Put the kaos.bin on root of your usb stick. Put stick into kpa . Hold both page buttons <> and turn kpa on to browse mode while holding the buttons.

This will sort it for sure

Babau · Dec 7th 2015

Yes, it works! Thank you, guys....Really!

DamianGreda · Dec 7th 2015

Quote from Babau

Yes, it works! Thank you, guys....Really!

skoczy · Dec 8th 2015

Quote from DamianGreda

Put the kaos.bin on root of your usb stick. Put stick into kpa . Hold both page buttons <> and turn kpa on to browse mode while holding the buttons.

How about making the recovery procedures sticky?

Share