Performance mode is loading some generic clean tone instead of the actual profiles

gabrielthorn · Aug 6th 2016

Hi there,

I've been using my Kemper for a while and started to use the performance mode when I bought the Kemper Remote. I have a performance having 5 profiles. The first 3 is working fine, however, anytime I switch to the 4th of 5th profile, it doesn't load the actual profile, it loads some generic clean guitar tone. When I turn the browse knob on the profiler and change the tone and switch it back, it does load the correct one, however, if I select channel 1-3 again and jump back to 4 or 5, it doesn't load the correct tone. Anyone experienced this issue before?

Cheers,
Gabriel

aleksivii · Aug 6th 2016

make sure that you have the slot enabled button on, it's next to the browse knob in perform mode. Also check that the amp block is on (where the amp, eq and cabinet softbuttons are).

gabrielthorn · Aug 6th 2016

The slot is enabled, and the amp block is on as well.

millstudios · Aug 6th 2016

Are you on the latest V3 (3.3 ?) Firmware or the latest V4 (4.06) Firmware ?

Ingolf · Aug 6th 2016

Quote from gabrielthorn

The slot is enabled, and the amp block is on as well.

Did you actually populate the slot with a rig?

whippinpost91850 · Aug 6th 2016

What ingolf asked

gabrielthorn · Aug 8th 2016

All the 5 slots are populated with a profile, and the performance is stored as well.

paults · Aug 8th 2016

Have you accidentally Locked the Amplifier Stack to a clean rig or to Off?

Press the Lock button, and see the Amplifier button lights up.

If pressing the Lock button makes the Amplifier button light up, press the Amplifier button, and press the Lock button again.

Ingolf · Aug 8th 2016

If @paults 's suggestion doesn't work (and I doubt it will because slots 1-3 sound as expected) I'd contact support.

Share