What are these 2 LEDS?

    Hello,
    I'm new to the Kemper Profiler.


    I wonder why every button 1-5 has 2 LEDs?
    as is step on the same button twice the selectet rig stays the same, but the bottom LED switches to the top LEDs,
    for what reason?


    Thanx

    This is for morphing (Or at least that's what I use it for).


    So, click the stomp pedal so the upper of the 2 LEDS is active. Change amp perimeters, for example a mid boost and gain boost for a solo for example. Or you could also add an effect as well. Click save on the kemper.


    Now when you click the button for the second time, it will morph to the new perimeters! Cick again and it goes back to your stock sound.


    I'm rubbish at explaining but hope that makes sense!

    For a deeper explanation and additional settings (morph crossfade times etc.) check out the morphing section in the reference manual : click here