Hello,
I am sending a stereo signal from my kemper to a power amp and a stereo marshal 4x12 cabinet WITHOUT the speaker simulation and I woukld like to send the same stereo signal to the P.A but. WITH the speaker simulation on.
Is it possible?
Thanx
stereo outs with and without cab simulation
- voodoohill
- Thread is marked as Resolved.
-
-
I have the same question? I believe this is not possible. Cab sim on/off seems only possible for the Jack/XLR outputs togheter and not separate. Is this correct? Would be nice if this is possible because you can have the power of the cabinet, stereo on stage and line out to FOH al in stereo!
-
No, but you can do it otherwise but you will loose stereo on your marshall cab.
Main outs with cab sim on to foh and monitor out with cab sim off to your marshall. You have to set your marshall from stereo to mono. Your power smp has to be bridged to mono.