Midi foot switch skips imported profiles??

Hi,

When using my MidiMoose foot controller with the Kemper, I can switch between stock profiles but imported profiles get skipped!

Example: profile 1 is stock, profile 2 is imported from rig manager, profile 3 is stock.
When I press button 1, I get profile 1, when I press button 2, I get profile 3!

I already contacted Tech21 support but they told me that the MidiMoose is a 'dumb' tool which could not skip anything or something like that and the fault
must be on KPA side (or on mine).

Any suggestions how to solve this?

Quote from hjscheffler

i think i replied to a very similar support ticket 2 days ago.

In which mode are you using the Profiler? Browse or perform?
In Browse mode you need to manually assign program change numbers to the rigs that you want to call up over MIDI. In perform mode each slot of a performance is already preassigned to a certain midi program change number and all you need to do is load the desired rig into these slots and store the performance afterwards.

Aaahhh!

I am dumb. I have never used/tried the perfom mode since! There it works! Thanks a lot