New Kemper owner here. I have the powered Kemper and a Marshall 2555 full stack. Is it possible to have the kemper power the left speaker and run the right output to my Marshall to power the second cab? Any help would be greatly appreciated.
Kemper combined with a Marshall head for stereo
- Crimson Ghost
- Thread is marked as Resolved.
-
-
I think you could run the DI out from the Kemper into the input of the Marshall.
-
New Kemper owner here. I have the powered Kemper and a Marshall 2555 full stack. Is it possible to have the kemper power the left speaker and run the right output to my Marshall to power the second cab? Any help would be greatly appreciated.
that should work
-
that should work
Thanks!
-
In my experience, the KPA sounds more defined than a tube head and therefore positions itself better in the mix. I would cut bass at the tube head. Just a sidenote.
-
i think it might be a bit out of phase from the small delay from the kemper. you may not notice this live.
-
i think it might be a bit out of phase from the small delay from the kemper.
good point. especially with one stereo-cabinet
-
Thanks guys. I'll keep that in mind.
-
I think this configuration wont give you a stereo fx. Powered kpa monitor out to your left cab is mono and main out to your marshall stack is mono. Be aware that the marshall will colour all your rigs.
-
Both cabs would be set to mono. I guess it just comes down to if the kemper lets you run the powered out as the left or right speaker or if it forces all outputs to be the same mono signal.
-
Probably the return of your head would be best suited.