What is the best way to make sure that I have Pure cab and Space set up for everything ( XLR outputs and other outputs) but not my cab out so I can run a 4x12 on stage (mine is powered unit) but have all of my other outputs with the pure cabinet and space engaged? I do not want pure cab or space engaged into my 4x12 cabinet… but everywhere else, yes!
I am just trying to keep things simple as I am new to this,
Thank you,
Keith
Setting up global pure cab and cab sims for all outputs except cabinet output…(powered Kemper)
- SQUAREHEAD
- Thread is marked as Resolved.
-
You can globaly set monitor cab off. This setting applies to monitor out AND cab out.
I think this feature was requested several time but maybe not possible related on hardware limitations.Have a look here:
Cab sim off speaker out, on with main output -
Pure Cabinet has only an effect in combination with the Profiler cabinet simulation. "Monitor Cab. Off" deactivates the cabinet simulation for the Monitor Output AND the internal power amp, so the Speaker Output effectively.
Space works only in stereo setups anyhow. I don't think, you will notice any difference in the mono signals of Monitor Out and Speaker Out.
-
if you plan to go mono into the board you should make sure to select Master Mono as the output source for the Main outs.
That signal includes the cab simulation along with the pure cab settings. -
once you have selected master mono you can use either one of the XLRs. They both will carry the same mono signal.
-
hjscheffler,
Thank you very much! -
Let us know how your gig goes!