couple bugs - 1. blank UI screen on start up 1 out of 5 times. 2. blank UI on shutdown, wont power off requires unplug.

    Couple bugs and I wasnt sure if these are already known
    Im on 5.5.2 (13463)


    1. Every so often after startup I end up on my last used rig page, when I boot to the browser, but there is no right data displayed. When this happens I cant switch to any other screen with the hardware knobs or software selection. Just stuck. Only a reboot will clear it. I added a pic for this .
    2. Every so often when I use the hardware switch to power down the screen will run through its normal shutdown display but then get stuck on the final blank screen. It will stay there indefinitely and never power down. The only way to clear is to unplug.

    I had a similar issue a couple of times yesterday. KPA became unresponsive. Couldn't even turn it off. The remote went dark, too. Only way to get both back on was to unplug. This happened after updating firmware.