Is it fair to assume that I can take the monitor out to the effects return of my amp for a dry middle signal and then send the stereo outsof the kemper to my stereo power amp for the wet sides? I want no effects in the middle and effects on the wet sides(duh 
)
Kemper and Wet Dry Wet
- tfridgen
- Closed
- Thread is marked as Resolved.
-
Unfortunately you cannot do that, the only think you can exclude from the monitor out is the cab emulation
-
might be a valid point for the feature request list.
-
Thanks! What about the direct out? It says something in the manual about using it as a mono send. Does this mean that it can be assigned at any point in the effects chain as a loop? Could I add the loop before the stereo effects and use the direct out for the 'dry' signal?
Yes, this is possible. not using the return you must use the mix value to balance the wet part
-
Actually, i think you can set your monitor out to not carry any effect signal and thus make such a setup possible. I saw this in the debug mode. But since the kemper guys gave the advise to not mess around there maybe you shouldnt
-
Can't wait to get one to try this out
-
Actually, i think you can set your monitor out to not carry any effect signal and thus make such a setup possible. I saw this in the debug mode. But since the kemper guys gave the advise to not mess around there maybe you shouldnt
That's exactly what I was trying to avoid...Thanks Till!!
Without jokes: the advanced system options in the debug mode are not made for normal users, the chances to borck the unit (if you don't know exactly what you're doing) are quite high.
-
Without jokes: the advanced system options in the debug mode are not made for normal users, the chances to borck the unit (if you don't know exactly what you're doing) are quite high.
With jokes : Normal users have an Axe FX
-
We will have a funktion like this soon!
CK
-
many men will be happy!
