Hi,
my voodoo lab ground control isnt recognised by the Kemper anyone got any ideas ? also has anyone used the cat 5 connection for switching patches ?
cheers
Hi,
my voodoo lab ground control isnt recognised by the Kemper anyone got any ideas ? also has anyone used the cat 5 connection for switching patches ?
cheers
You can use only the midi (1 way) connection, not the CAT5
You can use only the midi (1 way) connection, not the CAT5
thanks i think i have worked it out ! but why have a cat5 connection?
why have a cat5 connection?
On the KPA? That is for the dedicated (upcoming) footcontroller
Hi
I have GCP connected to the kemper, and this is working fine!
Hi
I have GCP connected to the kemper, and this is working fine!
TheViking
How do you have yours set up? Are you controlling the stomps and the amps?
Hi, i have a Ground control with Kemper also but can't switch stomp boxes on and off with it ! any thoughts anyone ?
I'm new to the KPA (See introductions), but the Ground Control is what I have somewhere around the house. It's the original one. I'll re-post with some ideas when I get to it as I'm having the same questions. Should work fine until the dedicated foot controller comes out, at which point I'd be happy to give Kemper some more business.
Hi, I´m using the GCP aswell.
It is working after programming the GCP a few times, it´s a little bit difficult:
Just do it in the 4 program mode, then check the right midi channel, program the CC numbers, which the kemper can receive...
then it will work fine.
Good luck!