Delay/Reverb Spillovers stops after 3 seconds after switching channel

1st Official Post

    Hi!


    See attached file!

    Limelight - 2024-03-10 00-53-07.zip


    I designed the fifth slot of this performance to have massive amount of delay/reverb to spillover when I change slot/channel.


    When staying at channel 5, I can hear the dly/reverb trail go as long as 20 seconds. However, when I switch to another channel (channel 3 in this case), the spillover abruptly stops after roughly 3 seconds.


    Delay & Reverb are in their right effect spot. Both effect mix position is set to "pre".

    In rig setting, the "spillover off" option is "disabled".


    I would like to know if it's by design or if I'm missing something!

    Thanks!

    Ok! thanks for the answer.
    However, in my case, the spillover cuts abruptly. Is this something I can control with a setting?

    • Official Post

    Yes, there is a setting in Rig Settings: "Rig Spillover Off".


    In addition make sure, that the new Rig isn't overloaded with complex effects. Spillover has a lower priroty and might be skipped, if the new sound requires to much processing power. This includes effects that are switched off. A clean up of the new Rig might help.