This is a very annoying behavior IMHO. The fact that I've connected a MIDI footswitch that sends MIDI clock to the KPA does not mean, by any stretch of the imagination, that I want all my rigs to suddenly start responding to MIDI clock. No, not even the ones I am editing with MIDI clock on. I am not The Edge, and I can only assume 7,000,000,000 people out there are not him either, including other KPA owners. I want a rig to respond to MIDI clock if, and only if, I specifically turn it on for that rig only. Currently not only does the KPA assumes that if it's receiving MIDI clock it should use it, but in the rig menu it's impossible to turn it off! I'm hoping this is a bug and not an intentional design decision.
For now this means I cannot use MIDI clock at all, because if I turn it on in my pedalboard the KPA starts to show this rather obnoxious and extremely annoying behavior. Please fix this. And I'm really thinking that over a year has gone by since the KPA was introduced and I shouldn't have to tell you this.
EDIT: And while you're at it, may I suggest that you separate the tempo sync parameter from time/rate? That way we can have tempo sync on a per-effect basis, so for instance delay could be tempo enabled and chorus not. Meaning, for each time-based or modulated effect one parameter would control tempo (1/1, 1/3{t}, ...., OFF) and a second parameter would control rate/time but would be only enabled when tempo would be set to OFF, otherwise it would just display the rate/time calculated based on the tempo parameter.