Spdif not working

    I hope I am just missing the obvious but I can't find my mistake. So here is what i do


    I connect the KPA Out to my m-audio FW 410 IN using a Coax cable.
    I make sure that the SPDIF Volume on the Kemper is 0.0 db and that my Soundcard is set to Coaxial Input on the spdif.


    Actually I don't know what SPDIF Out Link does, so i always try both ways..


    Anyways - i dont get any activity on my Soundcard. It has a light that should show spdif activity but it just doesn't do anything.


    I did a systemreset on the Kemper (i am on 1.6 btw) and downloaded the newest drivers for the FW 410.


    Any Ideas what I am missing?

    Press button "Output" and make sure Spdif-out (watch at display) is activated. If the cable-length is no longer than 2-3 yards you may take an ordinary coax-cable. Using longer distances a real SPDIF cable would be a better choice.


    Best regards ... Evo

    Edited once, last by Evoneos ().