How do you output rig mono and DI guitar in one SPDIF signal?

Hi,

I think I remember reading on here about a user that managed to record his mono amp profile out AND his DI guitar over the one SPDIF output.

I usually record via SPDIF ok, and up until now, I have been taking the through signal from the back of the KPA and putting that into my soundcard directly.
Of course this uses up another cable unnecessarily, and not to mention the extra ADDA converting that is ongoing with the DI signal (not that it makes a huge difference).

So, how do you set up the Kemper to output the Mono amp sound on one of the SPDIF channels, and the DI guitar signal on the other SPDIF channel?

Or can this simply not be done?

Thanks

Quote from tylerhb

Btw, you can create output presets. This makes changing the output configuration very simple. Afterwars you can just press the output button and then use the browse knob to change your presets.

Thanks for the tip! I didnt know you do that!
I'll look into the output of the SPDIF mod thing menitoned above....

Hmm...Guit/Mod does seem to output the stack, but I cant get it to output any effects on the stack side.

Ie, I get the stack (Amp, EQ, Cab) section in the right output, and the direct guitar signal in the left output. But I want the stack and effects in one output and the direct guitar signal in the other.

I dont mind if the effects go from "Stereo" to "Mono".... but I need some effects to go with my solos as I record.

So far I've left it to "Master Stereo" and I just take a line from the direct output on the back of my KPA into my interface....
But does this add another stage of AD conversion for the guitar direct, or is the guitar direct a proper through direct (ie, it completely bypasses any and all processing in the Kemper, conversion included)?

Thanks